Does anyone know how the X21 does overall?
Just that I have never seen many passengers on it at all.
RE: Arriva North East: Latest News & Discussion - May 2015
Skip to main content
(04 May 2015, 8:42 pm)mb134 wrote Did you get the chance to drive 7534?
Forum Moderator | Let us know if you have any issues
Service Manager, Coatham Connect
(05 May 2015, 4:49 pm)Tom wrote Does anyone know how the X21 does overall?
Just that I have never seen many passengers on it at all.
Forum Moderator | Let us know if you have any issues
Service Manager, Coatham Connect
(05 May 2015, 4:51 pm)tyresmoke wrote Doing ok I'm told, though the extra peak ones are being withdrawn which probably tells us about the usage of those particular journeys. I know this will enable the PVR at Stockton to drop by one.
(05 May 2015, 5:03 pm)mb134 wrote Speaking of X21's (Ashington one this time), I got off a 7504 that, once I alighted, would have had 3 passengers to take to Newcastle...
Forum Moderator | Let us know if you have any issues
Service Manager, Coatham Connect
(05 May 2015, 6:40 pm)mb134 wrote Was going through Bedlington around 5.45 (towards Newcastle).
(Should've pointed out that this was today)
(05 May 2015, 6:53 pm)Dan wrote Imagine the flow will be out of Newcastle towards Ashington at that time? Likewise in the opposite direction on the morning peak.
You'll find that the majority of services have one-way traffic at peak times.
(05 May 2015, 6:55 pm)mb134 wrote I understand that, however I recall when I used to get that particular run (and the one earlier), and it carried more than 3 passengers. If I remember correctly, the lower deck always used to be at least half full, and there were always passengers upstairs as well (when the service was Olympian operated in 2012)
(05 May 2015, 6:57 pm)Dan wrote Perhaps the one in front was late and got the majority of the passengers, then? I obviously don't know - just providing suggestions.
It's unlikely that converting the service to "Sapphire" specification has actually seen a decrease in passenger numbers.
(05 May 2015, 4:50 pm)tyresmoke wrote Of course I drove it from Washington services to Metrocentre, then 4814 from the services back to Darlington. Managed drives of the 2 Streetlites while at the rally too, only fair that we each get a turn in each other's buses! lol
(05 May 2015, 7:51 pm)mb134 wrote Forgot to reply to this earlier on!
How was it to drive?
Forum Moderator | Let us know if you have any issues
Service Manager, Coatham Connect
(05 May 2015, 8:33 pm)tyresmoke wrote It was really nice, bit slow taking off due to Econospeed but it was otherwise decent. Very smooth but then you'd expect that with only 900 miles on the clock lol! Was nice to drive an ADL product again, wish we could have had something along the lines of the Perrymans E300 there yesterday for our Sapphires rather than Streetlites.
(05 May 2015, 8:36 pm)mb134 wrote Is Econospeed installed on all E400's?
Not liking the Streetlite's like?
Forum Moderator | Let us know if you have any issues
Service Manager, Coatham Connect
(05 May 2015, 8:38 pm)tyresmoke wrote Yes I believe the ADL range were the first to be fitted, followed next by the VDL Pulsars - although we have suffered problems with getting it fitted to those, this is currently being worked on and a re-worked setting tested on a single Pulsar (Stockton's 1458)
I'm not a huge fan of the Streetlites, yes they do the job and cheaply but Sapphire was designed to be a premium brand and I think they've slipped up by buying low quality stock for it. They appear to be very reliable, though, and obviously the micro-hybrid setup produces fuel savings but I just feel they're not fit for purpose on a high spec bus route. The ride quality isn't great and they're very low to the ground, which means if you're in the front half of the bus it feels like you're riding on the road.
(05 May 2015, 8:54 pm)DaveyBowyer wrote Why are Arriva fitting Ecnospeed on already fuel efficient vehicles? If it was B9s or N230s for most routes, I'd understand but the ideal environment for the Cummins ISBe is for a setup to give plenty of power and torque across all speed ranges thus reducing stress and labouring on the engine. If setup correctly and maintained correctly, then they're cracking little buses but I can only help notice that Arriva are going a step too far with all this eco nonsense.
Econospeed is a dynamic throttle controller that allows a vehicle's maximum road speed, engine speed, and maximum rate of acceleration to be limited by any customer defined criteria.
By electronically restricting the vehicles maximum rate of acceleration and forcing earlier gear changes by limiting maximum revs Econospeed encourages economical and careful driving. It is a fit and forget system with no training or management required.
It simply means that over-revving a vehicle will not be possible but full power will still be available.
EconoSpeed is connected between the accelerator pedal and the Engine Control Unit (ECU). It constantly monitors acceleration demand from the driver, with the throttle pedal, as well as monitoring the engine and road speed of the vehicle via a Controller Area Network (CAN).
When acceleration is at an optimum level, EconoSpeed allows output to the ECU, as much throttle as the driver requests. However, if EconoSpeed detects that acceleration demand is (or is about to become) too high, it restricts acceleration to a pre-determined level. This level is based on the speed the vehicle is travelling at the time.
(05 May 2015, 8:59 pm)mb134 wrote How exactly do they work, taking what I can from Tyresmokes earlier post, does it only affect pulling away? That's the only time I've ever noticed a 14/64 reg Enviro being a tad sluggish, they do fly when they get going
Forum Moderator | Let us know if you have any issues
Service Manager, Coatham Connect
(06 May 2015, 3:52 pm)Tommy_1581 wrote In relation to the passenger numbers on X21/X22 - my usual 0900 X21 from Ashington-Newcastle is very busy by Bedlington heading into Newcastle.
However, a stereotype has been set. From day one, vehicles were breaking down, complaints came streaming through about breakdowns, use of 57-reg buses, the power sockets not working etc. Potential passengers have been put off by the fact that Sapphire E400s are being towed.
In all honest opinion, as a daily user of X21, I've seen passengers giving up on the bus when it fails somewhere and continuing their journey on foot/different service.
People expect and say that Sapphire will get passenger numbers on the X21/X22, because of the likes of the 7.
If Arriva bought an entirely new fleet of Enviro400s for the X21/X22, I don't think that I'll be sat here typing this, but commending Arriva on their investment.
(06 May 2015, 4:07 pm)mb134 wrote However, as has been stated previously, us talking about it on here isn't going to help, so until someone at Arriva figures it out, people will just have to deal with it unfortunately
(06 May 2015, 3:52 pm)Tommy_1581 wrote In relation to the passenger numbers on X21/X22 - my usual 0900 X21 from Ashington-Newcastle is very busy by Bedlington heading into Newcastle.
However, a stereotype has been set. From day one, vehicles were breaking down, complaints came streaming through about breakdowns, use of 57-reg buses, the power sockets not working etc. Potential passengers have been put off by the fact that Sapphire E400s are being towed.
In all honest opinion, as a daily user of X21, I've seen passengers giving up on the bus when it fails somewhere and continuing their journey on foot/different service.
People expect and say that Sapphire will get passenger numbers on the X21/X22, because of the likes of the 7.
If Arriva bought an entirely new fleet of Enviro400s for the X21/X22, I don't think that I'll be sat here typing this, but commending Arriva on their investment.