RE: Arriva North East: Latest News & Discussion - February 2015
7401-6 appear to have the Northumbria address. Or the one I noticed certainly did.
Skip to main content
(03 Feb 2015, 3:36 pm)Cock Robin wrote So how do Redcar drivers drive 2827/8 then?
(03 Feb 2015, 3:39 pm)Cock Robin wrote 7401-6 appear to have the Northumbria address. Or the one I noticed certainly did.
(01 Feb 2015, 11:55 am)Kuyoyo wrote God knows.......So, there's a plan to remove most non-DDA MPD's - but what about the 5 remaining V and W reg examples at Darlington after these moves take place. Is it a case of the new Streetlites for the X1 allow these to be removed by giving an overall balance of numbers at Darlington or will a further shuffle (of what??) be required?
For 1733/42/50/95/96 (and 1758) to be removed from service, Darlington have to receive 2852-61, allowing 2803/4/5/7/8/26/9 to move to Stockton releasing 1769/71/2 to join Darlington's 1760/7/91 in moving to Blyth. As 2857/61 are still being used by Jesmond and the rest appear to be in storage there, it's a case of waiting for spare drivers to allow the moves to take place
(04 Feb 2015, 7:25 pm)aureolin wrote Am I missing something here, or can someone tell me exactly how long it takes to 'type train' a driver on a new bus? The whole concept of it actually sounds like health and safety gone mad.
(04 Feb 2015, 7:25 pm)aureolin wrote Am I missing something here, or can someone tell me exactly how long it takes to 'type train' a driver on a new bus? The whole concept of it actually sounds like health and safety gone mad.
(04 Feb 2015, 8:21 pm)mb134 wrote I've been using the X21 frequently this past week and I noticed a few things:
So I think they could be better off doing this:
- All journeys did have passengers, however only the peak time runs were full, most had a maximum of about 30 on. (From what I saw). So loads at peak times would be spread, helping reliability.
- The timetable seems quite tight, and if there is a large amount of people from upstairs getting off over a few stops, it puts the bus back a few minutes.
- When the bus was late, it seemed like the driver really had to push to get back on time.
32x Volvo B8RLE single deckers, increasing the frequency of both services to every 10 minutes, so there is a combined frequency of every 5. At peak times, this would mean buses were less cramped, and more convenient
These would, I think, be better suited to the route, as they allow for quick entry/exit, have a more powerful engine and you would have buses that are actually pretty full, all of the time.
The current Enviro 400's could then be used to upgrade another route, or provide additional spares.
Thoughts?
(04 Feb 2015, 8:21 pm)mb134 wrote I've been using the X21 frequently this past week and I noticed a few things:So I think they could be better off doing this:
- All journeys did have passengers, however only the peak time runs were full, most had a maximum of about 30 on. (From what I saw). So loads at peak times would be spread, helping reliability.
- The timetable seems quite tight, and if there is a large amount of people from upstairs getting off over a few stops, it puts the bus back a few minutes.
- When the bus was late, it seemed like the driver really had to push to get back on time.
32x Volvo B8RLE single deckers, increasing the frequency of both services to every 10 minutes, so there is a combined frequency of every 5. At peak times, this would mean buses were less cramped, and more convenient
These would, I think, be better suited to the route, as they allow for quick entry/exit, have a more powerful engine and you would have buses that are actually pretty full, all of the time.
The current Enviro 400's could then be used to upgrade another route, or provide additional spares.
Thoughts?
(04 Feb 2015, 8:24 pm)Dan wrote Can't help but feel it would make the costs of running the X21/X22 go through the roof.
The advantage of double deckers is that they provide the extra capacity when it's needed; instead of having more peak time runs to combat full buses at this time, double deckers only require the one bus (and hence driver) and lowers costs. The advantage of light-weight double deckers is that it allows for savings on fuel.
(04 Feb 2015, 8:24 pm)Dan wrote Can't help but feel it would make the costs of running the X21/X22 go through the roof.
The advantage of double deckers is that they provide the extra capacity when it's needed; instead of having more peak time runs to combat full buses at this time, double deckers only require the one bus (and hence driver) and lowers costs. The advantage of light-weight double deckers is that it allows for savings on fuel.
(04 Feb 2015, 8:26 pm)RobinHood wrote Running 32 vehicles would almost certainly put the services at a complete financial loss.Oh god yeah, didn't think of the financial side (other than the initial outlay).........
(04 Feb 2015, 7:25 pm)aureolin wrote Am I missing something here, or can someone tell me exactly how long it takes to 'type train' a driver on a new bus? The whole concept of it actually sounds like health and safety gone mad.
(04 Feb 2015, 8:35 pm)Andreos1 wrote The dashboard layout of a bus and associated buttons/controls can differ per model. Even slightly.
I believe some operators issue booklets these days, with a photo of the dash and labels.
(04 Feb 2015, 8:35 pm)Andreos1 wrote The dashboard layout of a bus and associated buttons/controls can differ per model. Even slightly.
I believe some operators issue booklets these days, with a photo of the dash and labels.
(04 Feb 2015, 9:04 pm)aureolin wrote I'm an outsider looking in here, so feel free to shoot me down, but this all seems like a bit of a faff on? Regardless of where the indicators, door open buttons, seat adjusters, etc are - it's still a bus. As long as you're licence to drive it, you know the height and length of it, then it shouldn't be an issue?
(04 Feb 2015, 9:04 pm)aureolin wrote I'm an outsider looking in here, so feel free to shoot me down, but this all seems like a bit of a faff on? Regardless of where the indicators, door open buttons, seat adjusters, etc are - it's still a bus. As long as you're licence to drive it, you know the height and length of it, then it shouldn't be an issueDon't give them any ammunition!
(04 Feb 2015, 9:25 pm)mb134 wrote I'm sure that, if common sense was applied, a driver could figure out what was what on a new vehicle type.It can cover the operators backs in event of an accident or incident.
10 minutes alone in a cab and I think they'd figure it out?
(04 Feb 2015, 9:32 pm)Andreos1 wrote It can cover the operators backs in event of an accident or incident.Ah right okay, didn't think about that...
Type train a driver, prove you have done it properly and if an incident occurs, then the driver will be culpable.
Even if you get a hire car, the company often show you around and share a few hints and tips specific to that vehicle.
(04 Feb 2015, 9:35 pm)mb134 wrote Ah right okay, didn't think about that...
Out of interest, who trains the person who trains the drivers?
Would an employee from ADL, for example, go down and train one driver, or is there a manual kind of thing?
(04 Feb 2015, 9:25 pm)mb134 wrote I'm sure that, if common sense was applied, a driver could figure out what was what on a new vehicle type.
10 minutes alone in a cab and I think they'd figure it out?
Forum Moderator | Let us know if you have any issues
Service Manager, Coatham Connect
(05 Feb 2015, 8:23 am)JoshP wrote Currently sat on ex P&R Solo on the 8.14 number 4 from Minors Crescent. It still has P&R and Durham County Council signs on the inside but I'm surprised to see a next stop announcement system inside too. It's not currently switched on. I'm on 2860 and the doors aren't working very well
Forum Moderator | Let us know if you have any issues
Service Manager, Coatham Connect